on 03-14-2011 10:28 PM
Hi guys i have a problem y have a BI system that load data from R3 when i load material codes with only numbers it works fine...but when i load a single number with a letter it give an error...
I donth remember where i can configure that BI accept letters on material code.
I hope somebody could help me
Regards
Hi,
Can i Know, what is the error?
you may have change the Data type of 0material Info Object, if it is so,
make the data type as Char
Best Regards
Obaid
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi guys i found the reason aparently there were some not printable characters that are part of the codes in R3 and they bring with the BI load and are those that cause the problem.
I add a little routine for delete that characters and it works fine now....
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
It allows characterstic also
sap deliver material 18 char
so it should accpet may be small letters of that material number
if when conevrsion is not happening OMSL tcode
maiantain the mataerila length as 18 and execute thaat
matnr_exit_input conversion and check the same.
check it once again it allows the char also.
Thansk & regasrds
sathish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
try omsl - tcode for material format. I beleive it's lexicographical.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.