Mapping doesnt appear in the connection between Actions (in Intergration)

[Former Member]

Hello,

In the Designtime i have create a Integration Scenario

In this Integration Scenario I have inserted 2 Actions

1 Action for Start and 1 Action for end.

Problem is now when I connect both Action over a connect they will not assign the Mapping .

When I want assign a Mapping it is unfortunately unchooseable.

can anybody say what is the reason af this problem?

Thanks in Advance

Best Regards

[Former Member · Accepted solution]

1 Action for Start  and 1 Action for end.

Make sure the Start Action contains the correct outbound message interface and the other Action contains the correct inbound message interface.

Problem is now when I connect both Action  over a connect they will not assign the Mapping .

When you create a connection, make sure you have given the correct outbound & inbound message interfaces. Check these thing then try again to assign Interface Mapping.

[Former Member · Accepted solution]

Hello All,

Thank you for your responses.

The Problem is solved.

The Problem was i have the start action and the end action in the same level, but that are only allowed in case of synchronous

scenario.

In case of asynchron scenario the end action should be in lower level.

I have set the action in lower level in graphical display. it works now.

Best Regards

[Former Member]

I would suggest you to check each Object of scenario ( With their namespace)

Check if they have created properly and In mapping You have taken the correct Message Types check their namespaces also whether taken messages types are created in correct namespaces.,,

and in Operation Mapping .. you have taken the correct interfaces .a agian check for their namepsaces,

It should appear , if every thing is correct.

regards

PS

[Former Member]

Hi,

if the mapping is available and the messages has been associated to the actions properly.. mapping will appear..

you need to explictly choose the operation mapping over there....

hope you have created operation mapping before this step...

HTH

Rajesh