02-28-2011 4:56 PM
I want to know the step by step or a complete example to set up a communication between two servers SAP using bgrfc.
I tried to make a configuration. But messages are not processed automatically. The state of the unit is green and the queue has the status "Queue is executable. " I can run a single unit using Analysis Unit -> Run Unit With Trace, and the message reaches its destination.
I use the program RS_BGRFC_SCHEDULER_MONITOR in the sender system but does not show any scheduler. At the destination the same program shows the scheduler.
The systems have Sap Netweaver 7.0.
SAP_BASIS SAPKB70015
SAP_ABA SAPKA70015
I would greatly appreciate any help,
Thanks,
Roger.
03-01-2011 1:58 AM
Hello,
Maybe you can check here and see if it helps:
http://help.sap.com/saphelp_nwpi71/helpdata/en/b5/1051421310c153e10000000a1550b0/content.htm
Regards,
David
03-01-2011 1:58 AM
Hello,
Maybe you can check here and see if it helps:
http://help.sap.com/saphelp_nwpi71/helpdata/en/b5/1051421310c153e10000000a1550b0/content.htm
Regards,
David
03-15-2011 10:09 AM
HI Roger,
Did u solve this problem, i have the same issue.
Regards
Maciej
04-07-2011 9:10 PM
Hello Maciej,
In our development systems, user
used in the Supervidor Destination was granted the role of "sap all".
This link explains about the actual permissions needed:
("Increase the efficiency of your RFC communications with bgRFC")
http://www.sappro.com/article.cfm?id=3338
Greetings..