Skip to Content
0
Former Member
Feb 25, 2011 at 12:45 AM

Parameter not working in CR basic for VS2008

32 Views

I'm having problems with parameter in report, under ASP.NET application it displays a prompt for the parameter, I enter a valid value but I get "The parameter is incorrect" when I submit the report. If I remove the parameter the report runs fine in the same application.

Using VS2008 and CR basic for VS2008.

The parameter is a database field PA-FC is equal to {?FC}. I created a parameter named 'FC'. Using OLE DB (ADO) connection.

When I run the report preview in VS it works fine with the parameter.

When I take the parameter out and change the selection expert to the same value '2', it works in the report preview and also in the application without any issue. If I add the parameter back, it works in preview but not in application.

Edited by: Brentmsdn on Feb 24, 2011 7:49 PM

Edited by: Brentmsdn on Feb 24, 2011 7:51 PM