Full stock removal functionality for 201 movement type

[Former Member]

Dear Friends

I am facing one problem with full stock removal. As per my requirement, system should remove full container to staging area there

the requried qtty will remove and the remainging qtty goes to another storage type. When I post 201 movement type, system is not picking the full container.

When I observe movement type it is using dynamic bin and I changed it to static bin and I created a bin in 911 and I did the positng it picking the full container.

My question is, I chaanged in movement type and is there any impact for the same.

Regards

Raghu

[Former Member]

Hi

The only impact I can think of is with the 'dynamic bin'setting the bin is the cost centre and with your change ALL of your Goods issues to cost centre will be in the same bin and so clearing these quantities out will not be so easy as when you create the TO to 'pick' the stock to clear it out it will not be able to pick the specific bin for the cost centre, However as all of tyhe stock is in the same 'bin' it should not be too much of an issue as it will jsut reduce the bin by the qty on the TO.

It just means that if you want to report on the stock in 911 then it will all be inthe same bin and you cannot differentiate as to which material was put there by which cost centre

Frenchy