Hello Guruu2019s,
When we process an IT0008 change, we are receiving an error that there is u201CNo Entry in Table T510 for the key 10*###** **** on 2/20/2011u201D. This is a new entry in PM Compensation Management Job pricing Pay Structures Define Pay Grades and levels.
With that said, I did not set this up originally and I am new in to this area of configuration. Also, I configured this new entry based on the instructions that were left by the previous co-worker.
Now, from the research that I have done so far, the configuration that I was instructed to key in uses Table T710 which is why I am receiving the No entry in T510. From the entire configuration that I have checked in our system, we have never used table T510. So why it is yelling at me now, I cannot figure that out. I checked the feature TARIF and there is no configuration with any of our employee group/settings, but it is active and the otherwise is calling a program RPCADD00.
Just a little more history, we have been in the process of implementing Performance Management & Enterprise Compensation Management with consultants. The consultants are gone, so I am not sure if they turned something on which is forcing this to look at table T510 now or not?
We are on ECC 6 with EHP4 and any direction would be highly appreciated because I am at a lost here.
Thanks,
Mike