LT1D - Inactive Status

[Former Member]

Hi All,

In WM when we perform the OPERATION in LT1D

There are 2 Line Items in a TO in which i Inactive the 1st Line and Active the 2nd Line and save

Then were do i get this INACTIVE STATUS

In which table i can see this value

Regards

Amey

[Former Member · Accepted solution]

While processing LT1D or LT12, you temporarily move them to inactive status so that further processing can be done at later stage. There is no field in the LTAP table that indicated inactive or active status. When you again try to confirm TOs in LT12 or LT1d, agains these lines are displayed in active lines area

[Former Member · Accepted solution]

Thanks 4 the reply.

I went for a LOGIC like for the INACTIVE Line IDOC

if NISTA Qty is "0" then generate an IDOC that means its inactive line item

Please let me know what you feel about this logic

[Former Member · Accepted solution]

NISTA = 0 means TO line not confirmed yet. so, I think your logic is fine

[Former Member · Accepted solution]

Thanks 4 the advice