Skip to Content
avatar image
Former Member

Uploading selection data to an ABAP selection screen

Not sure this is the best place for this question but here goes.

When a user is presented with a selection screen from an ABAP they have the option to upload data from a text file. This works fine for single value lists but I cannot get this to work for ranges.

I have tried tab & comma delimited files, xls and plain fixed width text and am always presented with the message 'lower limit is greater than upper limit'.

Regards

Paul.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • Best Answer
    Aug 19, 2004 at 04:03 PM

    Hello Paul,

    this is a tricky one. When you are on a range tab, each line in the file has to follow the format "LOW&&HIGH" where LOW is smaller than HIGH (plain text). You always have to specify both LOW and HIGH!

    Regards,

    Marc

    SAP NetWeaver RIG, US BI

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Paul,

      You are thanking a poster for his answer.

      Please next time also give him points.

      See: /people/mark.finnern/blog/2004/08/10/spread-the-love

      This time I did it for you.

      Remember: When you ask a question you also assume the responsibility to assign points.

      Please check your other questions and if the answers were good.

      Spread the love and give some points.

      Thanks in advance, Mark.