Skip to Content
0
Former Member
Feb 15, 2011 at 04:22 PM

IPC control for added rework operations

145 Views

Dear Experts,

Can you please, help me with the following case:

I have a production order and IPC control for certain operations.

The system has created an inspection lot (03).

During the results recording (with operation confirmation) one piece is reported to be for rework.

The trigger point was activated and a new operation for rework was added to the production order.

The new operation for rework also has an inspection point (the same as in the production order - freely defined, no quantity or time dependency) and also has a quality characteristic.

My expectation was that after the new operation has appeared in the production order either the created inspection lot should be updated for the new operation and its characteristic or a new inspection lot should be created for the new operation.

However nothing happened - where did I go wrong or what is missing?

I will gladly supply additional information on demand.

Looking forward to hearing from you,

Rumi