Skip to Content
0

Failed to create calculation scenario when activating PA

Dec 10, 2016 at 08:01 PM

71

avatar image
Former Member

I added around 30 new key figures on a planning area copied from SAP2. When activating this PA, I received error message "Failed to create calculation scenario" - see below.

When I check this PA, all key figures are showing in active status now. Also one of the Information message in log shows "Planning area is activated". But it's actually not activated.

Since this error message doesn't point to any specific key figures, there is no clue where to start investigation.

Can anybody please help throw some lights here?

--------------------------------------------------------

E - Failed to create calculation scenario "SAPSOPG"."SOPHT2TEST14HT2TEST"

I - An exception was raised

E - An exception was raised.

E - SQL Message: column store error: fail to create scenario: [34001] Internal error during parsing calculation model;

---------------------------------------------------------

Thank you,

Wilson

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

Lingaiah Vanam Dec 15, 2016 at 08:33 AM
1

Hi Wilson,

It is very difficult to identify the root cause. Please raise OOS message to SAP.

or

I suggest to copy SAP 4 planning area and test.

Best Regards,

Lingaiah

Share
10 |10000 characters needed characters left characters exceeded