Skip to Content
avatar image
Former Member

Installation Test Drive 6.20 Error Data1

Hello,

I ve got the WAS 6.20 testdrive version from the SAP Booklet and ran into the problem as below

Info: EXTRACTSAPEXEDBDATA1 SyCoprocessCreate 2 816

Creating coprocess SAPCAR ...

Info: EXTRACTSAPEXEDBDATA1 SyCoprocessCreate 2 816

Creating coprocess SAPCAR ...

Warning: EXTRACTSAPEXEDBDATA1 InternalInstallationDo 2 816

SAPCAR returns with error 4.

Error: EXTRACTSAPEXEDBDATA1 InstallationDo 2 816

Phase failed.

Error: Main {} 2 816

Installation aborted.

I just inserted the kernel CD into the drive, SAP DB was installed with no problem, and when it came for the data load the problem occured.

I expected a pop up window telling me to insert Data 1 CD but negative, at the beginning the Instgui just wanted to know where the kernel CD to be found and where to place the SAPDB. There was nothing to say about the data CD's. I copied the kernel CD on hard disk, mounted the Data CD without any luck.

Is it really just inserting CD and that's it, and did someone had the change to give InstGui the paths or drives for data CD's?

Thanks for Help

Uwe

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Aug 11, 2004 at 01:01 PM

    Hello,

    so I found out that the target directory - with default C - doesnt have enough space and therefore hangs. However within the setup program I do not have a dialog to change the default entry. Is there any possibility to do so.

    Thanks very much in advance.

    Regards

    Uwe

    Add comment
    10|10000 characters needed characters exceeded