Dear Sir
I have a material X.In the inspetion set up ,only inspection type 01 is maintained.In the inspection type in material master following check boxes are ticked
1.Post to inspection setup
2.Skips Allowed
3.Automatic UD
4.Serial numbers poss.
Then i created PO for the material then I did MIGO.The material came into Quality inspection.A lot was generated.The status of the
lot is REL CALC SPRQ
When i try to do the result recording system is giving me message
Characteristic results cannot be recorded
When i went to do the diagnosis it is showing me the following details
Diagnosis
You cannot record any characteristic results for this inspection lot. The material master has been set up for the existing inspection type in such a way that results recording is not supported.
Procedure
Confirm defects for this inspection lot or select another inspection lot in which you can confirm the characteristic results.
How i can do the result recording.Please guide
With Regards
Debasish