Skip to Content
avatar image
Former Member

Error in Proxy generation.

When I go to SPROXY transaction. It gives me an error saying "No connection to integration builder(only local data visible)" and doesn't show anything (software componenets & all) there.

Also, when I try to read the help document there and try to run the Report "SPROX_CHECK_IFR_CONNECITON" it says "Integration Builder data not understood".

Does any body has any clue about this ? Thanks in adavance.

Amrish.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Aug 04, 2004 at 08:51 PM

    Amrish -

    Is your Integration Server Destination maintained correctly? Try going to txn SXMB_ADM, and from the "Configuration" tree choose "Integration Engine Configuration." You should see that youa re configured as an "application system," and you should seeb the URL for your Integration Server (most probably as an HTTP RFC destination). Check that this destination is properly configured (it should point to the pipeline entry point on your integration server - http://<host>:<icmanport>/sap/xi/engine/?type=entry).

    HTH,

    Paul Medaille

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 06, 2004 at 09:56 AM

    Thanx Paul. You were right!!That was not maintained but even after maintaining it says the same thing again.

    Any more clue ?

    Also, onething I noticed after maintaining the application system there ,When I pressed the "Check" button there, The log says that "No access to the system landscape at present" with RED icon. Is it because of that ??

    Thanks in advance....

    Amrish.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi!

      > The log says that "No access to the

      > system landscape at present" with RED icon. Is it

      > because of that ??

      Check SLDCHECK, SLDAPICUST and the configurations in the Exchange Profile.

      I remember I once had the same error message in SPROXY.

      SLDCHECK indicated that there was no problem with the connection to the SLD. However, the connection to the Integration Builder was not working any more and the WAS was only able to display cached software components and

      SPROXY was asking for a password. I solved the problem when I corrected the password for XIAPPLUSER in the Exchange Profile -> Application Systems.

      Regards, Tanja