Skip to Content
0
Former Member
Jan 27, 2011 at 06:38 AM

EHP1 Update Using SAINT - Reg

25 Views

Dear Friends,

We are updating Solution Manager from SP16 to SP 23 using SAINT in ABAP. I have added all the requirements and updating getting SAINT. The Provouge and the Check requirements phase is over. After that it takes a very long time (more than 48 hours)in the * DISASSEMBLE* state. I have checked the Slog. it shows "sapmnt\trans\tmp\SAPKITLORB.SM3 is already in use(87410,87420,87430 etc). I am waiting for 3,2,1 sec etc ". This is the only log shows with reduction in seconds.I have restarted the SAP during disassemble state too, but again it continues with the same log. Pls let me know, Whether i could continue or any otther steps to get imported.

The STATUS/REMARKS in SAINT Shows "The Addon will now be imported with the displayed Queue"

With Thanks,

Lakshmikanth T