Result Listing in QE72 is grouped by Operation/Activity

[Former Member]

Hi Experts,

In QE72, the results of listing is by Inspection Lot + Operation/Activity.

Can anyone know how to make the list shows Inspection Lot only?

I have tried modifying the layout but still showing many lines same per inspection lot if it contains more than 1 operation/activity, even deleting both operation/activity and short text.

I remember (and key users also) months ago.the list i only inspection lot.

Regards,

Daniel

[former_member42743 · Accepted solution]

QE72 is for inspection points which are by operation. You can have a different number of inspection points for each operation. In addition, the inspection point identifier can be different for each operation. So how could you run this list and NOT have it display by operation level? I guess you could have it pop up a second window to have you select the operation after you select a lot. But SAP didn't program it that way. So no... You can't influence that layout to have only one line per inspection lot.

FF

[Former Member]

Hi all,

Noted the characteristics of QE72, I have asked users to revise their expections.

Thanks for helping.

Regards,

Daniel

[Former Member]

Make sure that you have not made any dynamic selection(Shift +F4) for "Operation/Activity" in selection screen.

If its there then only "Operation/Activity" will come into picture

[Former Member]

Hi SujitSND,

I and all users have never made any dynamic selection.

Is there any place I can check?

Regards,

Daniel

[Former Member]

I can recognize only Dynamic selection (in the Selection screen of the QE72 where you enter plant ,material etc) can be a reason otherwise any selection profile made as a default.