on 01-17-2011 10:40 AM
Hi Guru's
I am loading 0material_attr, getting error again and again as mentioned below:
Error message from the source system
Diagnosis
An error occurred in the source system.
System Response
Caller 09 contains an error message.
Further analysis:
The error occurred in Service API .
Refer to the error message.
Procedure
How you remove the error depends on the error message.
Note
If the source system is a Client Workstation, then it is possible that the file that you wanted to load was being edited at the time of the data request. Make sure that the file is in the specified directory, that it is not being processed at the moment, and restart the request.
please anybody help me in this regard.
Hi Manna,
Replicate the DS once, then activate your DS, transformation/transfer rules etc. Then try to load the data.
Right click on the DS--> Replicate Metadata. Activate DS & then activate Trans/transfer rules.
Make sure that you delete the red request before executing the new IP/DTP. If you are executing the Init request, make sure that you delete the already existing init request. (To delete INIT req> goto menu> Schedule> Initialization for source system>select the request--> Delete if it is red. Otherwise you can continue with Delta load)
Hope it helps & resolves youir issue.
Regards,
Pavan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Now I getting following error
Missing data packages for PSA Table
Diagnosis
Data packets are missing from PSA Table . BW processing does not report any errors. The data transport from the source system to BW was probably incorrect.
Procedure
Check the TRFC overview in the source system.
You can get to this log using the Wizard or following the menu path "Environment -> Transact. RFC -> Source System".
Removing errors:
If the TRFC is incorrect, remove the errors listed there.
Check that the source system is connected properly to the SAP BW. Check in particular, the remote user authorizations in SAP BW.
Hi Manna,
goto the path Environment -> Transact. RFC -> Source System as mentioned in the error. It will ask for source system ID & password. Enter & login. check if anything is struck over there. If so, execute it manually or press F6.
You can also check SM58 trans for tRFC in BW system. If it is in Red, execute it manually.
You can also refer the below thread:
Hope it helps & resolves your issue!
Regards,
Pavan
Edited by: PavanRaj_S on Jan 17, 2011 5:05 PM
problem solved
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.