Error: Requested hierarchy selection & is incorrect in the source system

[Former Member]

Hi Expert,

I not sure where to start to check the error, but i started with checking the connection and it look good.

This is the program running in the source : SBIE0001. Please help if someone encounter this problem before

Individual message:

Requested hierarchy selection & is incorrect in the source system

Error message from the source system

Diagnosis

An error occurred in the source system.

System Response

Caller 09 contains an error message.

Further analysis:

The error occurred in Service API .

Refer to the error message.

Procedure

How you remove the error depends on the error message.

Note

If the source system is a Client Workstation, then it is possible that the file that you wanted to load was being edited at the time of the data request. Make sure that the file is in the specified directory, that it is not being processed at the

[former_member186445 · Accepted solution]

check that the hierarchy you selected in the infopackage actually exists. you can check the load also in R/3.

ask an R/3 consultant to take a look at the hierarchy in R/3 to see if there are any errors. make sure there are no duplicate nodes.

M.