Skip to Content
avatar image
Former Member

Creating a template with border

Hi Experts,

I'm using smartforms in 4.6C

Lately I have a task to draw a template (or table) that have a header column design like this :

A                              B
------------------------------------------------
|     xxxxxxx     |     xxxxxxxxxxxxxxx   |
|   xxxxxxxxx     | --------------------- |
|                 |  xxxxxxx   | xxxxxxx  |
------------------------------------------------

which have 1 header column that look like merge vertically (A) and 1 header column that look like merge horizontally (B) .

In ECC6 I can make the print out like this with only manipulate the border of the template. But the problem is I have to make this smartforms on 4.6C where I cannot found the border function like the ECC6 has. The only bordering function I have found in this version is to border all cells, not border all cells, etc. I'm also cannot selecting each cell that I was used to do in ECC6.

Any help would be appriciated..

Thx before

Edited by: . Febrian on Jan 12, 2011 5:38 AM

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Jan 12, 2011 at 07:41 AM

    Hi,

    In this case, you can design two windows one for A and one for B.

    Regards,

    Antim

    Add comment
    10|10000 characters needed characters exceeded