Skip to Content
0
Former Member
Jan 08, 2011 at 06:09 AM

Webi report data & the corresponding BW Query data do not tally.

42 Views

Hi all,

I am running a Webi report (XI 3.1) over a universe that is built on an SAP BW Query. The data in the report is regarding sales, and the grand total of the 'Sales Amount' as per the BW Query is about 1Million, which is correct. However, when I run a Webi report based on the same BW query, taking ALL the objects from the query (without any conditions and filters), the 'Sales Amount' figure comes out to be only 50K instead of 1Mn(as above). I'm not sure why this figure is so drastically reduced in the Webi report.

When I remove some objects from the query, Webi displays the correct figure of 1Mn. But these are the objects that are very much required in the report for multidimensional analysis. Dropping these objects would defeat the purpose of the report. The BW query too includes these objects during its execution and then displays the correct sales figure of 1Mn.

Any help will be greatly appreciated.

Regards,

Alok.