Please adjust base unit and coversion factor

[Former Member]

Hello Frinds,

When I am going to change purchase info record, I am getting the error "Please adjust base unit and coversion factor". Base unit in info record and material master are same.

I don't understand reason for this error. can anybody help me to resolve this issue?

Thanks,

Bhairav

[ongryann45]

There's a condition inside the program SAPMM06I that requires you to have the same NETPR and EFFPR field from EINE, Debugged this and saw:

Hope this helps
Regards,
Ryann

[ludo_devos]

This message was moderated.

[JL23]

when SAP issues this message " Please adjust base unit and coversion factor" (message number 06 365)

then it compares MARA-MEINS with EINA-LMEIN .

Use SE16 and check those fields in MARA and in EINA.

I dont believe that your base unit in material master is equal to info record.

If nothing had happened to the units, then SAP would not issue such a message.

You can as well check the change history in material master to see whether there were changes made to unit of measure and conversions.

[Former Member]

Hello Jürgen,Thanks for your reply.

I have checked the fields you said. In MARA it is showing base unit of measure as EA and where as in EINA it is showing base unit of measure as blank (no value).

How can we correct this issue? System keep on giving this error in ME13. System did not defualt EA in info record base unit of measure field.

Expecting your reply.

Thanks,

Bhairav

Edited by: Hari P Peddi on Jan 4, 2011 1:01 PM

[JL23]

what value is shown in EINA-MEINS field?

[Former Member]

It is blank, it is not showing any value there.

Edited by: Hari P Peddi on Jan 4, 2011 1:08 PM

[JL23]

use ME12, enter vendor number and material number, nothing else.

execute and enter an order unit

[Former Member]

I did the same thing. But system is giving the said error.

[JL23]

before or after you maintained the order unit there?

below this order unit is the conversion rate between order unit and base unit.

if you have EA for order and base unit, then you should see there 1:1, or jsut miantain it this way if it is not automatically coming.

[former_member329706]

Check whether you had maintain the conversion factor in Material master the same should be maintained in PIR also.

[Former Member]

Base unit of measure and order unit both are same.

[Former Member]

Dear Bhairav,

Check in the Inforecord General data in the sub-screen Purch order Unit of Measure and in Purch Org Data-1 screen- on "conditions" sub- screen for any alternate units are maintained and compare this in Material master "Additional Data" screen for the same conversion"

Umakanth R

[JL23]

and what is the order unit in your info record. and what is the conversion rate between base unit and order unit in info record and material master?

[Former Member]

Hello,

My Base unit of measure and order unit both are EA. I have created purchase organization data conditions in info record.

Thanks,

Bhairav