Switch off GRC 10.0 AC Risk Terminator?

[Frank_Meyer]

Hi folks,

while customizing a customers GRC 10.0 the Risk Terminator caused a dump at the plug-in PFCG. We do not use the Risk Terminator, so at first I put all customizing entries to "no" but this did not change anything. As the customer is just very busy rebuilding role in the PFCG I changed the connector to a dead end system and the work could go on.

Is there a way to switch of the Risk Terminator in a proper way? (I do not have rights to make changes in the plug-in-system but there will be someone who has, when i will be at the costomer next week.)

Best wishes

frank

[Frank_Meyer]

error-risk-terminator-1.jpg

error-risk-terminator-2.jpg

error-risk-terminator-3.jpg

error-risk-terminator-4.jpg

Hello Baithi, these days I changed the plugin-settings, but we kept the connector disconnected, which is ok for the customer.

Regards

Frank

[former_member197694]

Hello Frank,

Please change all the settings in Plug in system and GRC ABAP system as per the link

https://blogs.sap.com/2016/02/22/risk-terminator-grc-10/

also share the share dump from ST22

Regards

Baithi

[Frank_Meyer]

Hello Baithi, thanks so far.

I had all configuration settings put to "NO" especially 1081 and 1882 riskterminatoreinstellungen.jpg

but the Risk Terminator still caused the dump in the PFCG.

Are there any settings that can be changed in the plugin system to get it solved?

Regards

Frank

[former_member197694]

Hello Frank,

The best option is to delete/disable all the risk terminator related configuration settings

https://blogs.sap.com/2016/02/22/risk-terminator-grc-10/

Regards

Baithi