Forecast Profile Assignment At Customer Level

[Former Member]

Hi All,

I would like to assign a forecast at a customer level that has multiple products that roll up to this one customer. Is this possible? When I enter one customer in the selection profile and load all of the item and then try to assign a forecast profile, it does not seem to hold the forecast profile and does not appear in the Assign Forecast Profiles to Selection (/SAPAPO/MSDP_FCST2).

Are there any good document on restrictions and rules for forecast profile assignments to different levels of aggregation. For example, do you always have to be at a specific level to assign are forecast profile to a selection?

Thank you,

Rumi

[Former Member · Accepted solution]

Hi Rumi

I think it should be possible to Assign Forecast Profiles to Selection via T-code (/SAPAPO/MSDP_FCST2). Please create respective selection in planning book as per your requirement. Then go to above T-code only give respective planning area and execute.

It will show you all the current selections with assigned FCST profiles. You also find few buttons on top. Please select the assign, which will take you to next screen for selection. You can given put the customer information in selection and execute which will give you all the selections with given customer.

Select your respective selection and than you can assign the FCST profile with some buttons from header.

Please read the following thread from SDN will give you more information about it.

Please let us know, if it helps you.

Thanks

Amol