Values for table SPROXSET

[Former Member]

Could someone give me an example of the values that should be in the R/3 table SPROXSET so that I can configure the connection for ABAP proxy generation using transaction SPROXY?

Thanks

Patrick

[Former Member]

IFR_ADDRESS host:8000/rep

IFR_PASSWORD XIPASS

IFR_USER XIAPPLUSER

HTH.

Pandari

[Former Member]

Hi,

when I am accessing transaction SPROXY, it's asking for userid and password.

Do we have to do any settings to access this transaction

Thanks in Advance

[Andrzej_Filusz]

Hi!!!

As far as I remember I didn't have to do any additional settings.

Please double check if you put the correct values from Exchange Profile (http://<host>:<port>/exchangeProfile) into SPROXSET table.

You can also check it using the following programs:

SPROX_CHECK_IFR_ADDRESS

SPROX_CHECK_IFR_RESPONSE

SPROX_CHECK_IFR_CONNECTION

Have a nice day,

Andrzej Filusz

[Former Member]

Hi Andrez,

Thanks for the prompt reply.

We have done the required setting in Exchange Profile as described in post installation guide.

Do we need to manually update SPROXSET table. If yes, please can u tell us from where can we get the values for updating in the table.

We checked the program given below.

SPROX_CHECK_IFR_ADDRESS

For the two described below, when we execute the program, it prompts for user id and password. When we put the user id and password it generates an XML page. But when we run it again it again prompts for the user id and password.

SPROX_CHECK_IFR_RESPONSE

SPROX_CHECK_IFR_CONNECTION

Thanks for all the help.

Regards

[Former Member]

Did you every resolve this. I'm running into the same issue.

Thanks