Skip to Content
avatar image
Former Member

PI7.11 - Can't get the message to AAE


ECC<---- -SoapAdapter(Synch)

> PI7.11 <


Use of Local Processing required in this project.

I've successfully completed Design work and then completed Integrated Configuration (all those tabs, Inbound processing, Receiver, Receiver Interfaces, Outbound Processing look correct)

Then I did the ABAP backend communication on the ECC side

(SM59-RFC Destination to point to AAE,

then SXMIF - defined Sender Interface,

then sxmb_adm - IE Engine Config.-->Specific Config where I added IS_URL.

Ran my test from ECC.

It's not showing up in RuntimeWorkbench/Message Monitoring/Adapter Engine

But I can see the error under Integration Engine that is not good (It should go from ECC----->AAE, local processing).

Question: SXMIF, Do I need to configure a RECEIVER ID as well?

2. In SM59, Is it necessary to enter a login/password? The reason I ask is that when I do the connection test, a pop up window (XISOAPApps) asks for username/password. When I fill in the username/password, the test goes successful!

Question is where do I enter this username/password for automation?

What am I doing wrong? Please advise...

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Dec 09, 2010 at 05:04 PM


    In RFC connection click on logon & security under security option -> logon procedure select Basic Authentication and

    enter the logon details save and test again.


    Kiran Nekkanti

    Add comment
    10|10000 characters needed characters exceeded