Skip to Content
avatar image
Former Member

Cannot assign deilivery to Shipment

Dear all,

In VT01N, i can't assign deilivery to shipment.

It just shows message:

Number of deliveries found: 0

Message no. VW852

I've checked Maintain transportation relevance for delivery types and Maintain transportation relevance for delivery item types.

So, what's problem?

Thanks& Best Regards,

Quanglv

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

5 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 03, 2010 at 12:59 PM

    Hi Quanglv,

    In delivery doc. level (vl02n), you must check whether the Picking and WM status should be C (fully). If it is not after picking and confirmation of your transfer order from LT03 and LT12 (confirmation, please try to add your delivery to your shipment document again.

    I hope it will work on it.

    Regards,

    Sinan

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 04, 2010 at 08:04 AM

    Hi,

    Check once Route has been maintained or not at delivery, transport tab.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 03, 2010 at 09:58 AM

    hi,

    this is to inform you that,

    what system saying is right because it is triggering from the Include LV50LF15.

    please check have you done total configuration for transportation module.

    please check and come back

    balajia

    Add comment
    10|10000 characters needed characters exceeded

  • Dec 03, 2010 at 10:02 AM

    Once you execute VT01N and after clicking the "Deliveries" tab on top left, a box will appear. Here under the tab "Delivery status", by default some value will flow. Maintain blank field here and execute.

    thanks

    G. Lakshmipathi

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 04, 2010 at 08:50 AM

    Hi le,

    Please check whether tou have made the route relevant for transportation.

    Please check if the route is determined in the delivery.

    The trans planning status in the Delivery doc trans Tab should be A or B then only the delivery will appear while creating shipment.

    Regards

    Mayank

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Mayank,

      I have same issue & could not find delivery document number while creating shipment cost. The trans status is C, Picking status is C and WM status is also C. I refreshed and also tried after few hours but my delivery is not appearin. Route is well defined with delivery type, item category. I shall appreciate if you trhow more light what area we are missing....Thanks