Reg : Problem USING EXIT_SAPLCMAT_001 for CIF transfer

[Former Member]

Hello Gurus,

I am workin on an object where in i have to use the exit " EXIT_SAPLCMAT_001" for the transfer some of the ECC material master data fields to SCM during the CIF transfer fields are

" MARC-DISP0, MARC-EKGRP, MARC-FEVOR, MARC-MMSTA ,MARA-MSTAE, MARC-FXHOR " to

"/sapapo/MATIO-ATT01, /sapapo/MATIO-ATT02, /sapapo/MATIO-ATT03 ,

/sapapo/MATIO-ATT04, /sapapo/MATIO-ATT05, /sapapo/MATIO-PRODH (SNP production horizon) " respectively .

But when i put a breakpoint in the exit " EXIT_SAPLCMAT_001" and run the t-code " CFM1" and "CFM2", the break-point is not gettin triggered. Please help .

[aparna_ranganathan]

Krish

Did you turn on the "enable debugging" option. The enable debugging option has to be enabled for the user exit to get triggered.

Thanks

Aparna

[hubert_spohn]

Please see the comment sI have written into the exit when using it:

*----

---

• OSS 828026: This user-exit is called up to three times during

• data transfer to a SCM system.

• Parameter IV_MAP_STATUS shows for which functionality

• the current call is made.

*

• '1': New material master data is mapped to analyze SCM-relevant changes into the SCM format

• '2': Old material master data is mapped to analyze SCM-relevant changes into the SCM format

• '3': New material master data is mapped for the CIF transfer

• '4': Location products for MRP areas are transferred

• '5': Material master data is mapped for the CIF comparison and reconciliation report.

*

• Remarks:

*

• - the target destination is not maintained in status '1' or '2'

• - the call with status '3' is done in an update task if immediate transfer

• is executed when changing a product. In this case it is not

• possible to debug this call. If necessary CFM2, CFP1 or RIMODINI

• have to be used for debugging.

*----

---

Hubert