Workflow is triggerred in golden client

[Former Member]

Hi Workflow guru,

i got a very unique scenario here. i did try to activate the standard travel request approval workflow. (ws20000050). in my environment, i do have two client for the development server. one is served as configuration client and another is served as unit testing client.

I also transport the necessary activation of the workflow from configuration client to unit testing client. However, when the workflow get triggerred, it is happened in the configuration client instead of unit testing client. (please take note that the portal is pointing to unit testing client.

Can anyone throw any light on what are the possible steps that i did wrong?

Regards.

[Former Member · Accepted solution]

Hi,

In the testing client use the transaction SWU0 to simulate the event.

It will show you the workflow's that are linked with the event.

Also you can create the travel request using the TRIP transaction and check whether the workflow is triggered or not.

If the portal pointing the Testing client, then the request should be triggerd in the testing client.

Thanks,

Viji.

[Former Member · Accepted solution]

Hi Viji,

i did the same as you mentioned. ithe workflow is triggered when i am doing the simulation of event also SWUD. however, it does not happen when i am doing the trip transaction. instead, it is pointed to the workflow in the configuration client.

Is that any other possiblity that it will causing it?

I vaguely remember that i did activate the binding in the configuration client for the workflow and transport it to the testing client. could it be the cause of it? if it is, is that anyway i can revert back to the original state?

Regards,

[former_member185167 · Accepted solution]

Sounds like the portal is pointing to the wrong client. The events are being created in the wrong client.

[Former Member · Accepted solution]

Hi,

If you create a Travel req is in testing client and is the workflow is triggered in the Config client?

If so check the table PTRV_HEAD in the both clients. In which client the trip data's has been stored?

If the trip data's stored in a Config client instead of Testing client, then you have some issue's with the clients.

You need to discuss with your basis consultant about the issue.

Thanks,

Viji.

[Former Member · Accepted solution]

Dear all,

The issue is resolved after restarting the portal.

Thanks for your all helps.