on 11-17-2010 11:43 AM
Hi All ,
I have just added a Key Figure as an attribute to a Master Data IOBJ . It has been added in the attributes and is Display Attribute by default . Now I need to change it to Navigational Attribute . Please suggest how can this be done .
Thanks & Regards
Garima
Thanks for the Response
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
To make a Key Figure as navigational attribute of a IOBJ you will have to take help of BEx Designer.
you can use a formula variable processed by replacement path to pull in the value of this KF attr into the query and use it in a calculation. There is also a How To doc for this...you can find it on SDN.
Cheers
Umesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Garima
Only in case of key figures we cannot change it from display to navigational.
If the info object is a characteristics then in the General tab of the info object if you select 'attribute only' then the iobj would be a display attribute only. If you leave it unmarked then you can use the iobj as a navigational atribute.
I am sure you know that these settings only mean if a IOBJ can be used as display or navigational. To use it as a navigational within another object you will have to change the settings from 'DIS' to 'NAV' for the said info object in the 'Attributes' tab of its parent info object.
Further if you use the parent info object in any data target / infio provider you will have to further mark the info object as 'navigational' while defining the attrbute of the said data target / info provider. The info object gets displayed in the data target / info provider attribute properties as 'parent IOBJ_info object'
Cheers
Umesh
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.