on 11-16-2010 2:50 PM
Hi Experts,
While performing withdrawal action through PA40, the system issues a error message "Position 50019335 not available"
what would be the error.
Regards,
Shadeesh.G
Hi,
Normally while doing withdrawal action, the position should be 999999999. Since you are getting this particular error message, please check in the infogroups configuration, wat operation type is given for the infotype 0&1. It should be delimit operation.
cheers,
Ayyaps
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please check the percentage of that Position, weather it is fully (100 percent) or partially filled.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Also when you perform the withdrawal action you may want to put the employee in Position 99999999.
Hope it helps.
Regards,
Edoardo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
While performing hiring action, i set the value 99999999 to default the position, when work center assignment had been done in PS module, system automatically populates the value ########## by overiding the value 99999999.
When i do the termination process for the same employee it says Position ########### not available.
Regards,
Shadeesh.G
Check whether position 50019335 is available and is active in the specified period.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.