Skip to Content
avatar image
Former Member

Question regarding Receiver Determination and Differente Namespaces

Dear sirs,

I have the following scenario:

I have a mail account read by a sender communication channel IMAP4 in namespace http://a. The message is sent to a receiver communication channel type XI delivering to an ABAP Proxy at the same namespace. Everything works fine here.

I need to split the route: Reading the same mail account and depending on the message received send it to an ABAP Proxy of namespace http://A or namespace http://B. The receiver determination does not allow to configure destinations of different namespaces.

Please someone could give me an idea how to solve this issue?

Thank you in advance.

Fabio Purcino

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Nov 16, 2010 at 08:29 PM

    Hi,

    maybe I did not understand correctly but you can do this with conditions in the interface determination.

    There, you enter two lines. One for Namespace A and one for one for Namespace B. For each line you enter the corresponding condition.

    Hope this was helpful.

    Best regards,

    Markus

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 16, 2010 at 08:46 PM

    Is the target is two different proxy ECC system???

    I didnt understand the requirement of sending the information to two different namespace??

    why the requirement is like that??

    If the target is same ECC with two proxy structure then why r u creating two name space???

    Chirag

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 17, 2010 at 10:40 AM

    Hi,

    There is the same ECC System with different ABAP Proxies.

    Depending on a value of a TAG the message has to be delivered to an ABAP Proxy or the other.

    Thanks,

    Fabio

    Add comment
    10|10000 characters needed characters exceeded