on 11-02-2010 3:11 AM
I have a Netweaver CE 7.2 System. I have run the Diagnositcs and Introscope Agent Setup successfully from Solution Manager, transaction Solman_Setup and from the Root Cause Analysis WorkCenter. All is Green.
Where I am at now is that in the IntroscopeAgent.profile I have noted the following:
introscope.autoprobe.directivesFile=#WILY_IS_AUTOPROBE_DIRECTIVES#
Is this incorrectly set by the installation? Should this not at least be sap_typical.jar,sap_sapjcm.jar
There is no documentation on this other than for the Manual Setup of Introscope.
Thank you.
I had already figured that you needed to make the manual entries. The installation suggests that this configuration is automatic.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
My system profile value is as below
introscope.autoprobe.directivesFile=sap_typical.jar,sap_ep.jar,sap_xi_typical.jar,sap_ep_iviews.jar
You might configured without selecting the correct Autoprobe Directives in Introscope agent Setup.
Check it in Diagnostics setup>Managed systems>Introscope agent>Introscope Agent Settings><SID>~JAVA and check the Autoprobe Directive selections.
Select the below
sap_typical.jar,sap_ep.jar,sap_xi_typical.jar,sap_ep_iviews.jar
and Apply.
Then check the value in profile.
Cheers
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi There
You can find the document using this link below
https://websmp202.sap-ag.de/~sapdownload/011000358700001995842008E
Best Regards
Jai Wardhan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.