on 10-28-2010 1:00 PM
Dear All , pls help how to display line item value and freight value in a single line report for po. is there any standrad report ? pls inform me.
thanks
sandip
Not bit sure,Check it in MB51 report,In change layout,add delivery cost(freight) field to right,,also add p.o no.,Copy,save layout.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Try with MEK32.
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Try with Tcode ME80FN for the line item PO value.
Regards,
BK
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
As far as my knowledge goes there is no standard report as per your requirement.
You can develop a report with logic first select Doc. condition no. (KNUMV) from EKKO table.Then for each KNUMV against each KPOSN select the required condition types (KSCHL) & its value (KAWRT) from table KONV
Regards,
Indranil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Is the freight a seperate condition type in the PO line item or header?
Don't think there are any standard reports which show PO condition details by condition type.
You can try to enhance ME2M/ME2L tcodes.
I know it is possible in ECC6.0, not sure about earlier versions. Through enhancement spots it would not involve huge amount of code but would impact performance of ME2* tcodes.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
104 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.