Skip to Content
avatar image
Former Member

Should we use negative condition in selection in HANA DB

I have this basic question about using negative (<>) or other relational parameters (LE, GE etc) in selection from application later on a HANA DB. Previously in conventional DB we used to avoid using any of this operators in selection statement where we had used an index, as this will force the selection for sequential read. Is the same concept true for HANA db as well? or we can use these parameters in selection now, if we have a HANA db.

Appreciate your help on this.

Thanks,

Kuntal

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Dec 08, 2016 at 09:27 AM

    Hello all,

    Any help on this will be helpful.

    Thanks

    Kuntal

    Add comment
    10|10000 characters needed characters exceeded