Skip to Content
avatar image
Former Member

Entire Message = JMS Payload

Hi,

I have to design an IDOC -> PI -> JMS scenario and have to configure JMS Message Headers (not SOAP Header).

I used UDF (and ASMA) to set the header attributes,DCJMSMessageProperty0, but the SOAP header is populated which is not as per my requirement.

So will this option in receiver JMS channel help me Entire Message = JMS Payload to get the header value in JMS message?

Thank you,

Pankaj.

Edited by: Pankaj Sharma XI on Oct 12, 2010 5:18 AM

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Oct 12, 2010 at 07:26 AM

    > So will this option in receiver JMS channel help me Entire Message = JMS Payload to get the header value in JMS message?

    No, this won't help you.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Stefan Grube

      Hi,

      You cannot see JMS header inside PI, you only can see it in Sonique MQ.

      Thanks a lot, was not aware of this part.

      Thank you.

      Pankaj.