Skip to Content
0
Former Member
Oct 08, 2010 at 11:41 AM

I/O CDP relevant input components in PDS with wrong quantity

116 Views

Dear Experts,

In my PDS, I have 2 components which are I/O type CDP relevant input. Problem is that in the PDS, these CDP component quantities are wrong in comparison with quantities maintained in the R/3 BoM Master Recipe.

Components are classified with a class type 023 in R/3 - batch specific unit of measure, and product master is classified with a class type 400 (CDP classification) in APO. Configuration schema is CDP in APO and as mentioned, I am using PDS instead of PPMs. Note that finish product, father, is not using any CDP class, it is only some of the components.

So problem is basically that the quantities are not right, it looks like it is not doing right the conversion of units of measure however for the non CDP components, it is doing it OK.

Component BoM quantity is 46 Kg and PDS component quantity is 46 BRL. Note that base unit of measure is BRL.

But If I check material master units of measure, I see that 1 BRL(Barrel) --> 1 BRL and then 75Kg --> I BRL (Barrel). Same for in the Product Master units of measure tab.

Am I missing something?

Thanks in advance

Regards

Carlos