Problem in Solution Manager Diagnotic Setup.

[Former Member]

Hi Gurus,

I'm performing Solution Manager E2E configuration.

In Basic configuration--> Diagnotic Setup I'm getting the following error.

Please suggest the solution. Pleasse check the below error.

ABAP/Solution Manager connection test failed : A failure occured while connecting to ABAP stack on xs05093sap sys=01 client=001 user=DDIC. Details : Connect to SAP gateway failed

Connect_PM TYPE=A ASHOST=xs05093sap SYSNR=01 GWHOST=xs05093sap GWSERV=sapgw01 PCS=1

LOCATION CPIC (TCP/IP) on local host with Unicode

ERROR partner '10.130.103.2:sapgw01' not reached

TIME Fri Oct 8 07:46:48 201

RELEASE 701

COMPONENT NI (network interface)

VERSION 38

RC -10

MODULE nixxi.cpp

LINE 2835

DETAIL NiPConnect2

SYSTEM CALL connect

ERRNO 111

ERRNO TEXT Connection refused

COUNTER 1

- ABAP/UME User store connection test failed : A failure occured while connecting to ABAP stack on xs05093sap sys=01 client=100 user=xakbnine. Details : Connect to SAP gateway failed

Connect_PM TYPE=A ASHOST=xs05093sap SYSNR=01 GWHOST=xs05093sap GWSERV=sapgw01 PCS=1

LOCATION CPIC (TCP/IP) on local host with Unicode

ERROR partner '10.130.103.2:sapgw01' not reached

TIME Fri Oct 8 07:46:48 201

RELEASE 701

COMPONENT NI (network interface)

VERSION 38

RC -10

MODULE nixxi.cpp

LINE 2835

DETAIL NiPConnect2

SYSTEM CALL connect

ERRNO 111

ERRNO TEXT Connection refused

COUNTER 2

- ABAP/BW connection test failed : A failure occured while connecting to ABAP stack on xs05093sap sys=01 client=001 user=DDIC. Details : Connect to SAP gateway failed

Connect_PM TYPE=A ASHOST=xs05093sap SYSNR=01 GWHOST=xs05093sap GWSERV=sapgw01 PCS=1

LOCATION CPIC (TCP/IP) on local host with Unicode

ERROR partner '10.130.103.2:sapgw01' not reached

TIME Fri Oct 8 07:46:48 201

RELEASE 701

COMPONENT NI (network interface)

VERSION 38

RC -10

MODULE nixxi.cpp

LINE 2835

DETAIL NiPConnect2

SYSTEM CALL connect

ERRNO 111

ERRNO TEXT Connection refused

COUNTER 3

Regards,

Ravi.

[mateus_pedroso · Accepted solution]

Check this note and reply the results.

Number 1008474

Short text Diagnostics Setup Wizard uses wrong ABAP client

[Former Member]

Hi There

You are getting this error cause the solman_setup >> Initial Config is not fully done , also you have to confirm

about your BI client detail in the solman system.

Would advise you to first finish the all steps of Initial config and other earlier steps in basic config.

Best Regards

Jai Wardhna

[Former Member]

hi

can you verify your java property sheet settings as stated in the thread

[|]

jansi