on 10-06-2010 5:24 PM
Hi,
I'm configuring SOLMAN and in client 100 I'm runnign SOLMAN_SETUP and until step 3 of initial Configuration, everything was ok.
I've created the SOLMAN_ADMIN on the first step, then the ABAP config, and on the step 3 when I click to open the popup to put the Solman_admin pass, the password that I put gives the error Authentication failed.
I've done reset in SM using SU01, I've added SAP_ALL and SAP_NEW to the user and nothing works...
Any idea?
Note: I've tried with J2ee_admin and the answer is the same. Also with my user and the answer is the same... Where can I go to solve this?
Edited by: Pedro Taveira on Oct 6, 2010 6:27 PM
Hi,
Try creating new userid with same previlage of j2ee_admin and see if it works.
Regards,
Deepanshu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
The 3rd step you mean Start J2ee config ,, here if you are getting the POP up for login and password then
you need to provide the J2EE_ADMIN and the password. the login and password is case sensitive so plz make sure
you are giving the right one ..
Best Regards
Jai Wardhna
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.