Skip to Content
author's profile photo
Former Member

Default Macros not disaagregating in SCM 7.0

Hi,

We have recently upgraded from SCM 5.0 to SCM 7.0.

We are facing a peculiar problem with Macros, when we load data in a SNP Planning Book, the data gets loaded successfully but when I am trying to disaggregate through Header Infromatinn Settings (Details ALL), then the Key Figure is not getting disaggregated.

When I change the Macros from a Default Macros to a Directly executable Macros and manually running it, the disaggregation is happening.

This was not happening in SCM 5.0, can someone please guide me what I missing here.

The Planning Book is an SNP planning book, and KF is a custom made Order Series KF.

Regards

Abhishek Sahi

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    author's profile photo
    Former Member
    Posted on Oct 18, 2010 at 03:02 PM

    Hi,

    This is happening because of the DRILL_UP and DRILL_DOWN macros in the DEFAULT and LEVEL Change Events.

    In SNP this macros no need to assign in the macros.

    We faced the same issue after upgrade to SCM 7.0 and after removing these working fine.

    Thanks, Saravanan V

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo
    Former Member
    Posted on May 05, 2011 at 02:21 PM

    Problem solved

    Add comment
    10|10000 characters needed characters exceeded