Skip to Content
avatar image
Former Member

operatiave project not copying from std templete

Hi,

I have created the coding mask as ABC&D/XXX/00 and created the Std templete as ABC&D/XXX/99

std templete as

when i am trying to create the project, by copying from std templete it is messaging as

WBS elements could not be included. Check your entry

Message no. CJ450

it is necessary to create the coding masks seperately for std. templete and operative project?

one coding mask on opsj, based on the same we create std templete and from the same by copying we can create operative project.

Regards,

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Oct 04, 2010 at 06:40 AM

    Hi,

    Check this note. Hope it helps.

    Note 719770 - Error message CJ450 when including WBS elements

    Regards,

    Gokul

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi,

      Thank you very much for the response.

      This note is relevant to 4.6 &7 it says it could not be implimented

      Since we are using ECC 6 EHP 4, please share if you have any updated note for the same issue.

      Regards,

  • Oct 04, 2010 at 10:16 AM

    This is because the operative WBS ABC&D/XXX/99 exists in your system

    This is standard behaviour as system exeocts you to replace the number and then include the WBS elements

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 26, 2013 at 03:05 AM

    This message was moderated.

    Add comment
    10|10000 characters needed characters exceeded