Skip to Content

1)Inactive risk id's showing in risk analysis report .

To create a custom rule set, I created new Riskid's, by using the same function combinations, from Global ruleset.

in the Custom ruleset, some rik id's i did Inactive , and for some risks changed the priority.

Generated rules successfully.

But still, both these changes are not implicated while doing risk analysis.

Regards,

Ganesh.K

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Mar 14 at 11:14 AM

    Hi Ganesh,

    did you assign the risk ids to the rule set? Did you run the analysis with the proper rule set?

    Also, check the generated rule details to see if there is any fancy combination that doesn't make sense and hence doesn't work. It would be helpful if you share some screenshots.

    Regards, Alessandro

    Add comment
    10|10000 characters needed characters exceeded

  • Mar 14 at 11:14 AM

    Hi Ganesh,

    did you assign the risk ids to the rule set? Did you run the analysis with the proper rule set?

    Also, check the generated rule details to see if there is any fancy combination that doesn't make sense and hence doesn't work. It would be helpful if you share some screenshots.

    Regards, Alessandro

    Add comment
    10|10000 characters needed characters exceeded