BPMO: Application monitor Table entry account

[Former Member]

hello, everyone,

Now I face a quesition about Table entry account. I want to limited the filters group by time, and the key figure was limited as following:

Field Name: Z_DA

Options: $Today

Unfortunately, I found the field Z_DA is Char type, with 10 length. I've no idea to figure out ut, is there anyone give me a suggestion?

My Solution is SAP EHP 1 for SAP Solution Manager 7.0.

and of course, please don't tell me write a program and using background job to monitor the table~ I ' m not good at this~

Thanks a lot!

[marta_sanchezaponte · Accepted solution]

Dear Lily,

The data field could be a CHAR10 if the format is as follows: 29.09.2010 (with the dots there are 10 characters)

In order to ensure that you are going to Setup the Table Entry Counter correctly in BPMon, I would recommend you to check

the selections in SE16 on the monitored system.

You can use transaction SE16 to clarify the selection parameters (like table name and filter criteria). The F4 helps in SE16 can also guide you about the field contents that you can select.

>Please see the details in:

>www.service.sap.com/bpm -> Media Library -> Technical Information ->

> Setup Guide - Table Entry Counter

> Chapter 1.3.2 --> Simulate data collector result in monitored system

I hope this helps you further,

With kind regards,

Marta

SAP AGS

[Former Member · Accepted solution]

Hi, Marta,

Thanks very much for your answer.

However, the key point is the Date Feild format likes 2010-08-04. I try to limite the select-options as 20100804, the result is empty, while the fact is not.

what can I do? Do u have any good idea? Thanks a lot.

[Former Member]

I try to use the method like Customer-exit. fixed the value and then i can do it.