Skip to Content
avatar image
Former Member

NWDI .SCA file

Hi all,

I have a changes to few components. I released all the activities. in assembly is it possible to combine only certain activites and create an .sca file?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Sep 27, 2010 at 01:42 PM

    Hi p734305,

    after importing into the CONS it is not really possible.

    Assembly means that the whole state of the software from the CONS/active workspace is taken for assemble.

    Therefore you cannot filter out which changes should go into the assembly since they already have arrived in the cons system.

    If you want to filter out changes that should not go into production then these changes should not be imported into consolidation before, since every change that is imported into cons will be part of the assembled software.

    You can also delete DCs in dev and transport them to cons so that they will be deleted before assembly. (such a deletion should be able to activate even if there are predecessor activities to be activated)

    Best Regards,

    Ervin

    Add comment
    10|10000 characters needed characters exceeded