CLEAN_REQREQ_UP SRM5.5 - Question re field entry

[Former Member]

Hi

Within SRM5.5 for clean_reqreq_up, in the classic scenario, does the logical system field require an entry ie the backend system or should it be left blank ?

The reason for the question is that if a held LOCAL PO is deleted, the end users check status does not show this when the clean program is run with the backend logical system input, but if left blank, the status does show in the check status graphical view.

We have always run clean program with the backend system in on versions 2.0c, 3.5 and 5.5 and we had no issues, but after a few support packs, this is now a minor problem.

OSS message was raised, but it seems that we may not now need a logical system in the field.

Can anyone advise on how the job is recommended to be set for the logical system.

Thanks

[former_member183819 · Accepted solution]

yes. i schedule this job for every 3 minutes .

if you have more than one backend system it is definetly required.

even you can create a variant and mention logical system if you want.

Muthu

[Former Member · Accepted solution]

completely agree with Muthu,

Define the job to run every 3 to 5 mins

Regards

Virender Singh

[Former Member]

Thanks to all

[Former Member]

Kay,

The Clean_reqreq_up job primarily uses entries in BBP_DOCUMENT_TAB table to determine which items to update in SRM. If you use a filter with backend logical system, it will only pick the items that are relevant to the backend system. Leaving it spaces will pick all entries in BBP_DOCUMENT_TAB.

SG