on 09-22-2010 2:42 PM
Hi,
I have configured an FTP VAN sender adapter from Seeburger. I am trying to connect to Sterling Commerce VAN and have configured all the parameters as what have been described in the Seeburger manual for FTP/VAN adapter. I am using a custom script as I need to change the mailbox for the polling to take place. Below is my custom script:
open [@Key=HOST] [@Key=PORT] [@Key=USER] [@Key=PASS]
cwd SD150xxx/
type [@Key=TRANSFERTYPE]
prompt
mget *
close
I configured the comm. channel to use this custom script as:
file:/temp/script.sh
When I activated the comm. channel and open the comm. channel monitor in RWB, all I get is this message:
Adapter has been started. (xxxxx) as node: xxxx
The polling did not take place although I think I've configured them correctly. The file from the mailbox is not being picked up by the comm. channel. Do you have any idea how to get this to work? FYI, I managed to configure the FTP VAN receiver adapter correctly and it worked. I just have problem with the sender channel but I did not know where I went wrong as the status in RWB did not state any error to the configuration. Pls help.
Thanks.
Issue solved.
We need to configure something in the Seeburger Workbench-Resource Management-Resources. The incoming channels need to be set to be greater than 0. The Seeburger FTP VAN adapter now works as expected.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.