09-21-2010 3:21 PM
Hi friends, I need some help.
I trying to apply corrections on ECC 600 with sap note for note number 1394582. When I load this note on SNOTE, this transaction load a lot of other notes (prerequisites). My doubt is about this prerequisites, some of loaded notes as prerequisites is from support package 13 and here we already have support package 13.
Its safe to continue this? Why SNOTE loads notes that already exist on R3?
Thanks a lot!
09-21-2010 3:31 PM
It may have loaded all the prerequisite notes. But it will only implement the notes that are delivered in higher patches.
However, if any of these prerequisite notes are applicable to your system, be careful for the manual steps involved if any.
G@urav
09-21-2010 3:28 PM
Hi!
Personally I like to check manually the source code changes after implementing SAP notes. I get the first correction within the note, and if the changes in the source codes are the same to the changes within the correction instruction, then the note was implemented correctly.
Regards
Tamá
09-21-2010 3:31 PM
It may have loaded all the prerequisite notes. But it will only implement the notes that are delivered in higher patches.
However, if any of these prerequisite notes are applicable to your system, be careful for the manual steps involved if any.
G@urav