Inspection Point for only one operation in an Inspection Plan

[Former Member]

Hi all,

I have an Inspection Plan with 4 Operations.

In only one of these operations I would like to have Inspection Points. Normally, all operations have inspection points.

Does anybody know if this is possible?

Regards,

Martin

[Former Member · Accepted solution]

Hii,

Inspection Points is assigned to the Inspection plan at the Header level, so you cannot allocate or omit Inspection point for one Operation or include Inspection points for other operation. It means one Inspection point for one Inspection plan.

If u want to record multiple Results recording, check with Sample drawing Procedure concepts. check and revert back.

[Former Member]

Ok,

there is obviously no way to have only one operation with inspection points.

Thanks for your answers,

Martin

[Former Member]

Though inspection point is defined at header level, if you want to record the multiple results for only 1 operation, it is possible.For other operations, do result recording only once.What's the problem?

Vishal