Skip to Content
avatar image
Former Member

DMR configuration for skip lot inspection

Hi QM experts,

My client needs to configure DMR for skip inspection lot.

Scenario Requires following steps:

1. Maintain PPAP approved status

2. After PPAP approval inspection of next 10 consecutive lots.

3. If all lots OK, system skip 1 in 2 lots.

4. Then system again checks next 6 consecutive lots, if there is any rejection again repeat step 2 else skip 1 in 3 lots.

5. Same cycle will repeat for skip 1 in 5, then skip 1 in 10, skip 1 in 20 and so onu2026

I am new to PPAP status and DMR. Kindly guide how to map this in SAP. What are the SPRO settings required and what master data to maintain for it, and what will be the process flow.

Regards,

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Sep 22, 2010 at 10:29 AM

    in need of experts Advice and Guidance.

    Regards,

    Add comment
    10|10000 characters needed characters exceeded