Skip to Content
avatar image
Former Member

Pricing error

Hi Seniors,

In the Pricing procedure i maintained condition record of 13.5% for the out put tax(for Rs 5000 tax should be Rs 675),but system calculates only Rs 594.41 which is only 11.8882%.also at header level it only shows the basic price of material say Rs 5000,but it should be 5000+tax(Eg Rs 5675).can anyone tell that where are the problems.

Thanks

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 20, 2010 at 07:11 AM

    Hi

    Kindly check the below

    1.Check the tax rate at the item level by going pricing analysis andif it shows 13.5% then check the steps calculation .

    2.Check the base price calculation in Pricing procedure it is included the tax or not

    If you have any further clarifications let me know

    Regards

    Dam

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 20, 2010 at 06:37 AM

    HI

    Kindly check the pricing date / document date for your order

    Also check the validity period of your condition record

    Suppose your Doc date is 01.01.2010

    and old condition record of 11.88% is maintained from 01.12.2000 to 10.01.2010

    New condition record from 11.01.2010 to 31.12.9999 then it will consider the old value

    So please check valid to and from date for new condition record in VK12/VK13

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 20, 2010 at 08:31 AM

    Hi,

    You should check the routines defined in pricing procedure for MWST condition type from SD > Basic functions > pricing > pricing control > Define And Assign Pricing Procedures > maintain pricing procedure. in that screen, please check whether proper routines are defined properly for Condition formula for alternative calculation type and Alternative formula for condition base value or not. I think you should not specify any routine for calculation type and should be defined as blank if you do not need any alternative calculation for your output tax condition. And for base value, you can define routine number 16 (Net Value + XWORKD) as a SAP standard routine.

    hope it will work on this problem.

    Regards,

    Add comment
    10|10000 characters needed characters exceeded