on 09-09-2010 11:46 AM
Hi All,
I have created a LSMW for changing user status on work order using transaction IW32. It does not change the status when i run the LSMW. In the recording for the LSMW, i select the radio button on the user status i want to select.
When i run the LSMW in the foreground, it does everything except select the correct status.
Is there a way to fix this or is it a problem with LSMW. I'm using ECC6
Kind Regards
Emanuel
Thanks Rakesh.
I have tried this now, but it still does not, I will try again tomorrow and let you know
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi ,
I am not sure whether it would work with LSMW but if your on ECC 6.00 ,Enhacement Pack 3 then you have BADIs which allow you to make collective status changes in IW38 .The below are those BADIs :-
BADI_EAM_RIAUFK20_FCODE_CUS1 :Implement Customer Function Code in Order List
BADI_EAM_RIAUFK20_FCODE_SAP1 :Implement SAP Function Code in Order List
Else if your on lower version then write up a batch programme which checks the PM Order types with specific status and sets user status using FM STATUS_CHANGE_EXTERN[This is used to set or delete User Status] in SE37 ..
regrds
pushpa
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
7 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.