Skip to Content
avatar image
Former Member

Problem Pulling of Material Code from R3 system to SRM server

Hi,

In the process of pulling the material from R3 to SRM server we are facing the difficulty of not getting the

material item code (product ID) not comming to the SRM server. The procedure that we follow is as under:

1) We execute the R3AC1: - This helps to set the filter for the product ID.

2) We execute R3AS :- It helps to know the destination from where the material should come. Thus we define the destination ie CRM.

3) We execute R3AM1: Here we give material code and it starts the initial load. Sunsequently we monitor the progess of loading. After the completion of the process we the message "Done".

4)Then we give transaction COMMPR01 to check whether the materail is reflecting in SRM system.

BUt we get the message NO Product found.

Also we tried this by deleting the queues through transaction SMQ1 and SMQ2.

Kindly suggest the remedy for not getting the product ID in the SRM server.

Thnks

suk4023

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Sep 08, 2010 at 04:25 PM

    Hi

    Did you check your Filters and Site configurations in SMOEAC in SRM. Also please check if you have configured the Middleware related tables in ECC properly or not.

    Regards

    Virender Singh

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 08, 2010 at 07:14 PM

    Hello,

    You can monitor SRM middleware cockpit using SMWP transaction.

    It should give you clues about your R/3 materials replication.

    Regards.

    Laurent.

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 08, 2010 at 07:22 PM

    see any erorr in SMW01 .

    Add comment
    10|10000 characters needed characters exceeded